How can I clear led alarm in my juniper after problem has been resolved? I find the command "clear led alarm", but in my CLI I have only:
root@EX2200-2501-03> clear l ^ 'l' is ambiguous. Possible completions: lacp Clear Link Aggregation Control Protocol information lldp Clear Link Layer Discovery Protocol information log Clear contents of log file root@EX2200-2501-03> clear l Where can I find "clear led alarm"?
1 Answer
The alarm will clear itself when you resolve the issues, typically. Though I have seen it where the event wouldn't resolve until the switch was rebooted.
If the alarm hasn't resolved itself, are you sure there aren't other alarms on the system? (i.e. request system configuration rescue save (here))
